Loader
Clear AllClose
Your cart is currently empty.
ORDER BEFORE 2 PM FOR SAME DAY DISPATCH
FREE NEXT DAY DELIVERY On all orders over £24.99! All other orders will be sent via Royal Mail 48
Total
£0.00
Free Shipping On All Orders
1000's of Products
Customer Service 7 Days A Week
Defra Certified Grass Seed
Sold out
-% Sale
£8.99
You Save: (%)
This product was viewed times within last hour

High Quality Predator By Ron Signature Goat Hide Tig Gauntlet Welding Gloves

Short description

Looking for a top quality hide welding glove that will never let you down? The Predator Tig Gauntlet Welding Gloves are made from a top-quality supple goat hide and finished with a 100% cotton lining on the palm and fingers.
Real time 19 visitor right now!
Hurry Up! Left in stock
Order in the next to get it by Thu, Dec 05, 2024

Availability: In stock

SKU: PRED6-1

Brand: Ivisons

Pack Size:

The Predator Tig Gauntlet Welding Gloves are made from a top-quality supple goat hide and finished with a 100% cotton lining on the palm and fingers. An efficient Twaron stitching of heat resistant thread is used to extend the life span of the gloves. They are also incredibly dexterous. The Tig Gauntlet Gloves is complete with a leather cuff.

Glove Features: 

  • Goat hide leather gauntlet
  • Reinforced leather thumb crutch
  • Twaron stitched heat resistant thread
  • 100% cotton lined palm and fingers
  • Leather cuff
  • Product Code: PRED6

Glove Sizing: 

One Size Fits Most - approximately a size 10
Large: 9.5cm - 10cm (measurement across palm)
Length - 13" (33cm)

In order to select the correct size of glove, simply measure across your palm at the point indicated in the picture. Then compare your measurement with the chart below to ensure that you select the correct size of glove for your hand.

We would recommend using a tape measure or ruler to get the right measurement. Our measurements are based on centimetres.

Where your measurement falls on the boundary of two sizes, we would recommend selecting the larger of the two sizes for a comfortable fit. However, if you would specifically like your gloves to be a closer fit, perhaps for work that requires fine movements, select the smaller of the two sizes.

    These items comply with the requirements of Module B of the PPE Regulation (EU) 2016/425 and the harmonised standard(s) referenced below.


    Note – There is no standardised test method at present for detecting U.V penetration of materials for gloves but the current methods of construction of protective gloves for welder’s do not normally allow penetration.


    The CE mark indicates that the product complies with the general requirements, as laid out in the PPE Regulation (EU) 2016/425: Personal Protective Equipment Directive, EN420 + A1:2009 Protective Gloves General Requirements.


    EN388:2016, EN407:2003


    EN388:2016 performance levels shown are taken from the palm area only.


    These gloves do not provide protection against electric shock caused by defective equipment or live working, and the electrical resistance is reduced if gloves are wet, dirty or soaked – this could increase risk.

    These gloves are great for but not limited too: Construction, Metalwork, Engineering, Agriculture, Forging, TIG Welding, Landscaping